Specification Power Amp AXL Audion A-10 DSP

Specification:
Model Characteristic	H-35	A-2	A-3	A-6	A-8	A-10	A-12
Out Power ( 8 Ohm )	2 x 350w	2 x 200w	2 x 300w	2 x 600w	2 x 800w	2 x 1000w	2 x 1200w
Out Power ( 4 Ohm )	1x700w 8ohm	2 x 350w	2 x 500w	2 x 1050w	2 x 1350w	2 x 1700w	2 x 1900w
Out Power ( 2 Ohm )	2 x 550w	2 x 500w	2 x 800w	2 x 1400w	2 x 1800w	2 x 2200w	2 x 2400w
Out Power ( BRIDGE ) 8 Ohm	1x1000w	650w	1000w	1750w	2300w	2900w	3000w
Out Power ( BRIDGE ) 4 Ohm	4 ohm	950w	1300w	2300w	2900w	3800w	4000w
THD+Noise@1Khz Full Power	< 0.03 %				< 0,035 %
IMD 60 Hz & 7 Khz, 4 : 1	< 0.038 %				< 0,04 %
Signal to noise Ratio	> 102dB				> 105dB
Output Circuit type	Class AB				Class H
Input Sensitivity	na	Selectable ( 0,77 V / 1,0V / 1,44V )
Output Connectors	3 binding post	4 Pole Speakon & Binding posts
Panel Controls	na	Front-2 input attenuators REAR-Ground lif, mode selection, compressor
Frequency Response	15Hz - 25Khz(+0/-1dB)
Slew Rate ( input filter limited )	40 V / uS
Damping Factor 1Khz@8 Ohm	> 400 : 1
Input Impedance	10K Ohm Balanced to Ground
Input Connectors	Female XLR - 3 & 6,35mm TRS Jack
Protections	Full short-circuit,Open-circuit,Thermal,Soft-start,DC voltage, Sub/Ultrasonic and RF
Led Indicators ( per Channel )	Active, Signal, Limit, Protect
Cooling	Front to back via 2 variable speed fans